NanoMind A3200
Versatile On-board Computer for Cube, Nano and Microsat missions
Feautures :
High-performance AVR32 MCU with advanced power saving features
512 KB build-in flash
128 MB NOR flash (On two dies of 64 MB each)
32 kB FRAM for persistent configuration storage
32 MB SDRAM
RTC clock
On-board temperature sensors
Interfaces:
I2C, UART, CAN-Bus
8 external ADC channels that can also be used as GPIO
External SPI with 3 chip selects
Cubesat Space Protocol (CSP)
GOSH interface for check-out
Attitude control system features:
3-Axis magneto resistive sensor
3-Axis gyroscope
3 bidirectional PWM outputs with current measurements
I2C interface for GomSpace Sensor Bus (GSSB)
Electrical features:
2 x 20-position hard-gold plated FSI one-piece connector
NanoPower BP4
Small and powerful battery module for CubeSats
Feautures :
18650 Li-Ion cells with a nominal capacity of 2600 mAh
Two configurations are available:
2P-2S: 6 - 8.4 V & 5.2 Ah
1P-4S: 12 - 16.8 V & 2.6 Ah
Integrated temperature sensors with digital interface
Battery heater
Auxiliary MOSFET switch (e.g. to drive thermal knives for deployables)
Stackable for increased capacity
Fits standard PC104
ISS launch compliant version availabl
3U Powerpack
The 3U Power Pack includes a power supply, battery pack and full solar panel set for a 3U nanosatellite:
1 NanoPower P31uS
1 NanoPower BP4
1 NanoPower P110UA
1 NanoPower P110UB
1 NanoPower P110UC
1 NanoPower P110A
1 NanoPower P110B
1 NanoPower P110C
4 NanoPower P110AS
4 NanoPower P110BS
Power Harness
Main features:
Photovoltaic power up to 60 W
Two regulated power buses: 3.3V@5A and 5V@4A
Up to six 3.3V@3A outputs
Up to six 5V@3A outputs
Battery capacity: 2600-5200 mAh
4U Solar Panel 40P6
Power Efficiency: ≥30%
Max Power: 9.63W
Effective area (8 solar cells): 241.2cm²
Internal By-Pass Diode: reverse bias protection
Solar Cells Thickness: 155μm ± 15μm
Sensors: Temperature and Sun (optional Gyroscope)
RBF: Available with Remove Before Flight pin
Voltage at max Power: 9.32V
Current at max Power: 1034mA
Panel Dimensions: 192.6mm x 166.2mm
PCB Thickness 1.6mm
Mass: ≤170g